Vacuum Hose Bracket



The drum sander on my drill press works great for sanding curves — but it produces a lot of dust. If you don't have a dust collection system, here's a handy clamp you can make that will allow you to attach the hose from a shop vacuum to your drill press table.


The bracket consists of two parts: a keyhole-shaped yoke, and a metal hose clamp that secures the yoke to the column of the drill press (see drawings). These parts are held together with a carriage bolt and wing nut. The bolt passes through a hole in the hose clamp and into another hole in the end of the yoke.


To allow you to tilt the yoke to the desired angle without loosening the wing nut, the hole in the metal clamp is slightly larger than the square shoulder of the bolt. And to provide clearance for the wing nut, there’s a rectangular opening in the yoke. Finally, the large hole in the yoke is sized to accept the hose from the shop vacuum.

5 comments:

  1. The flat part of the paddle are also filed sharp, thus taking out large shavings similar to what you get from a wood lathe. For drilling wood the paddle bit is fast but to crude for good finish work.

    ReplyDelete
  2. Very Very Informative Blog..!!! Keep Writing and Sharing The Amazing Content

    Best Random Orbital Sander For Woodworking Under $100

    ReplyDelete
  3. Woot woot. This is really amazing the way you explained the thing very clear. The concept is basic so even a newbie can understand. Thank you for all.
    Diwali Ki Shubhkamnaye
    दिवाली की शुभकामनाएं

    ReplyDelete
  4. This comment has been removed by the author.

    ReplyDelete